Insulating the walls of your house this winter is extremely attractive to Gr 32 Systeme Optima Isover Gr32, as the main advantage of doing this is saving on their energy bills and adding value for their home.
The main grant relating to home insulation which can be available from the Sustainable Energy Authority of Ireland (SEAI) is the Home Energy Saving (HES) scheme. Homeowners can acquire this grant if they wish to put money into enhancing the energy efficiency of the dwellings through insulating the walls of the house.
The year once the house was constructed will in all probability determine the type of insulation required. When the house was built since 1920, the home will most likely have cavity walls and almost certainly, when the house was built after 1950. Solid walls are definitely the other main construct of your home.
Cavity Walls will have two skins of brick, a treadmill brick and something concrete block, with a gap in between, where air circulates and so prevents water penetration. By insulting this gap may prevent air circulation, trapping the air and thereby stopping heat loss by up to 65 per cent.
Insulating cavity walls, however, requires every exterior wall to become treated at the same time. Therefore, it is best suited coming from a cost viewpoint for homes that are heated throughout long periods. This kind of insulation is not practical to get a block of apartments, unless the whole building has been insulated simultaneously.
For cavity walls, there are two main home insulation methods that are the dry method and also the foam method.
The dry method utilises mineral-wool fibres or expanded polystyrene beads blown through holes drilled on the outer top of the wall up until the cavity is filled and insulation is finished. This process also ensures the optimum use of materials used.
The foam method can be produced at your location and pumped from the holes burrowed on the outside wall. The foam dries after a couple of days and solidifies, and it should be recognized for timber-framed homes.
Solid walls can be insulated in a different way, by either insulting the outside of the walls or line the inner top of the wall. Both of these methods can lead for the joinery, electrical and plumbing supplies being affected.
One other downside of the method is that it is very expensive and may alter the visage of the building involved. This really is caused as the cladding required on the exterior wall is definitely an elaborate process, affecting pipes, windows wcuiuh doors. These characteristics may have to be repositioned to allow for the insulation.
By lining the inside wall, skirting boards, picture rails, architraves, lights, sockets and radiators may be affected and will have to be repositioned because of this. Using a thermal board can be used to insulate the inside wall also by fixing the boards to battens. This can be done by attaching the thermal board direct to the walls having a board recommended adhesive, with the additional fixing of screws to hold the thermals boards in place.